User`s manual

12 Microtek ScanWizard Pro for Mac OS X
Scanner Probe
This command shows the scanner information on your SCSI, USB, or FireWire
chain. If your scanner does not show in the Scanner Probe dialog box, make
sure your scanner is properly installed, connected, and turned on, and then click
the Probe button. For details on connecting your scanner, refer to your scanner
hardware installation guide.
Current Scanner Info
This command provides information about your current scanner. When you
choose this command, a dialog box appears showing the scanner model, the
USB ID number, and the firmware version.
Scanner Model
The scanner model (and its SCSI, USB, or FireWire ID number) is shown at the
top of the scanner. If you have multiple scanners on your system, all the
scanners are shown with their respective IDs, and the current scanner is
indicated by a check.
Only one scanner can be accessed at a time. To switch among various scanners,
select the scanner to be used.
SCSI / USB / FireWire
devices on your system
(including your scanner)
Click the Probe
button to update
scanner information
on the SCSI/USB /
FireWire chain
Choose your
hardware
interface here
The scanner displayed with its SCSI,
USB, or FireWire ID number. The
current scanner is marked by a check