Instruction manual

6
When successfully unlocked, the
screw will push out a little,
protruding slightly from the bottom
of the scanner.
3.2.2. Shipping the Scanner
If you have to transport the scanner, you will need to lock the scanner back. Follow
the steps below:
1. Turn off the scanner if your
scanner is on.
2. Turn the scanner back on. The
scanner’s carriage will move to the
Stand-by position in 5 minutes.
3. When the indicators on the front
of your scanner stop blinking, use a
screwdriver, and then push and turn
the locking screw clockwise to the
locked position. When the screw
has been tightened, this indicates
that your scanner is locked.
4. Turn off your scanner. The scanner is now ready for transport.
3.3. Connect Scanner
To the power adapter
1. Connect the power cord to the back of the scanner
2. Plug the power cord into a power source.
To the high-speed USB cable
1. Connect one end of the cable to your
computer
2. Connect the other end of the cable to the
scanner.
3. Press the power button at the front panel of
your scanner, and wait for the lights to stop
blinking and stay on steady.
The system will detect your scanner
automatically.
3.4. Scanner control software
ScanWizard Bio