Specifications

Microtek ScanPotter Reference Manual 21
Calibrating Settings Window
If your scanner support the Smart Calibration function, when you click the
Calibrate Scanner button, you will see a window appear as below:
Calibration Mode Smart
When you check this option, the ScanPotter will memorize the calibration values
generated by different scanning settings. Next time, when you perform a scan
job with a same value of scanning settings, the scanner will skip the calibration
step and directly perform a scan job. This mode enhances the scanning speed
obviously when you often scan materials sharing same scanning settings.
Calibration Mode Typical
If this option is selected, the ScanPotter calibrates your scanner before
performing a scan job if the scanning settings are changed. If not, the scanner
will skip the calibration process and start scanning immediately.
Reset all calibration data
By clicking the Execute button after this option, the ScanPotter clear all saved
calibration data; therefore, the program will need to re-calibrate your scanner
and to re-memorize the calibration value when you perform the next scan job.
Also, when you click the Execute button, a pop-up window appears to remind
you if you are sure to clear all the saved calibration data.
Reset current calibration data
By clicking the Execute button after this option, the ScanPotter clear the
calibration data with current scanning settings, which means that the program
will need to re-calibrate your scanner and to re-memorize the calibration value if
your next scan job carries the same scanning settings as the current values used.
This option only delete the calibration data you are using presently. Other saved
calibration data are not affected.