Specifications

16
Comparison table with the conventional models
Function to remove the scratch and dust on the film
Place a check mark for [Digital
Masking Unit] in [Operator
Selections].
You can set the [Digital Masking Unit]
ON or OFF in the [Operator
Selections].
Unnecessary
D-ICE PCB (standard)
D-ICE control PCB (standard)
Scratch mend PCB 1 x 2 (option)
Scratch mend PCB 2 (option)
Data change over PCB (option)
DIMM (option)
Digital Masking :Option
Place a check mark for [DIGITAL
ICE Correction] in [Operator
Selections].
Unnecessary
D-ICE PCB (standard)
D-ICE control PCB (standard)
DIGITAL ICE:Standard
Installing the
software
Registration in the
mode
PCB
The conditions for functioning the scratch and dust removal function on the film
2130
33_2
Scratch removal function on the base side and the emulsion side of the film
(Digital Masking:option)
Scratch removal function on the base side of the film (DIGITAL ICE:standard)
Scratch and dust
removal function
on the film
Important
• As for the scratch and dust removal function on the film, in addition to the conventional
DIGITAL ICE, the Digital Masking (the scratch removal function on the base side and the
emulsion side of the film) which is developed by the NKC is added.
• When explaining about the scratch removal function on the base side and the emulsion side of
the film, please call it Digital Masking which is developed by the NKC.
Note
• The Digital Masking Unit (option) consists of Scratch mend PCB 1 x 2, Scratch mend PCB 2,
Data change over PCB, and DIMM.
• If the Digital Masking Unit is attached, a check mark is placed for the option registration
automatically.
www.minilablaser.com