User`s manual

Hardware Installation 2-7
Locking models with a latch-type lock
1 Turn the scanner off and then back on. The carriage will
move forward a bit and then return to its standby position.
When the carriage stops moving, turn off the scanner.
2 Turn the scanner on its side to locate the carriage lock. Pull
the latch (the carriage lock) down (or out) until the handle
on the side of the latch locks onto the chassis. Make sure
the latch is pulled out completely (not just halfway). You
don't need to re-insert the original piece of styrofoam
under the latch.
POWER
READY
Pull carriage lock down
If the carriage lock comes off:
If you pull the carriage lock down when the carriage is not in
the home position, the carriage lock may come off. To replace
the carriage lock, do the following:
1 Unplug the cables from the scanner.
2 Put the SCSI ID on 7.
3 Turn on the scanner. The carriage will start moving
towards the back of the scanner.
4 Turn off the scanner when the lamp is halfway towards
the back.
5 Insert the lock into position, and push it in all the way.
6 Change the SCSI ID to a number between 0 to 6.
7 Turn on the scanner and wait for about 30 seconds until
the carriage stops moving.
8 Turn off the scanner and pull the lock to properly lock the
carriage.
Note
In the event of a scanner malfunction, or if Item #4 does
not work because there is no power, you can also rest the
scanner on its back and wait for the carriage to start
moving to the back.