User`s manual

2-6 Microtek User's Guide for Windows
Locking models with a screw-type lock
You need to lock the scanner carriage if you wish to ship back
your scanner for any reason. The carriage must be locked to
prevent the mechanism from moving during shipping and getting
damaged in the process.
Important
Microtek will not be liable for scanners that are damaged during
transit because the carriage had not been locked or was not
packed in the original or authorized packaging.
1 Turn the scanner off and then back on. The carriage will
move forward a bit and then return to its standby position.
When the carriage stops moving, turn off the scanner. Be sure
that the carriage is in the standby position before you tighten
the locking screw. Otherwise, the carriage won’t be locked
properly and can get damaged during shipping.
2 Turn the scanner on its side and locate the locking screw at
the bottom of the scanner. To lock, turn the locking screw
clockwise one-fourth turn while pushing it in simultaneously.
The screw should stay in and not pop back out.
Locate lock at bottom of
scanner, then turn screw
clockwise to lock
Locking the scanner carriage
For scanners with parallel-port connectors (such as the
ScanMaker V300, V310, V600, etc.), there is no need to lock the
scanner.
Note