User`s manual
Table Of Contents
- Copyright
- Table of Contents
- 1: Basic Concepts
- 2: Hardware Installation
- 3: Software Installation
- 4: Sample Scanning
- Color Plates
- 5: Reference
- Overview
- ScanWizard for Windows
- The Preview Window
- The Settings Window
- Output Image Parameters
- Image Dimension controls
- Image Adjustment controls
- Image Enhancement Tools
- The Window Expansion button
- The Information Window
- The Scan Job Window
- Appendix
- Specifications
Hardware Installation 2-3
Operating the Scanner
3 The fluorescent lamp inside the scanner should be on too by this
time. The lamp should never go off while the scanner is on.
Once the scanner is properly connected, you can perform a power-on
test. To do this, turn on the scanner, and you will see the following:
1 The POWER indicator on the front panel of the scanner lights up.
2 Next, the READY indicator beside the POWER indicator flashes
briefly. After a 30-second warm-up period, the scanner carries out
a self-test, with the scanner carriage moving back and forth about
a half-inch. If no problems are detected, the READY indicator
stays lit.
Note
Note
If there are problems with the POWER and READY
indicators, see the
Troubleshooting
section in the Appendix.
If the scanner lamp doesn't come on, starts to flicker, or gets
dim, see the section
Replacing the scanner lamp
at the end of
this chapter.