User`s manual
Table Of Contents
- Copyright
- Table of Contents
- 1: Basic Concepts
- 2: Hardware Installation
- 3: Software Installation
- 4: Sample Scanning
- Color Plates
- 5: Reference
- Overview
- ScanWizard for Windows
- The Preview Window
- The Settings Window
- Output Image Parameters
- Image Dimension controls
- Image Adjustment controls
- Image Enhancement Tools
- The Window Expansion button
- The Information Window
- The Scan Job Window
- Appendix
- Specifications
Hardware Installation
2
This section provides information on installing the
hardware for your scanner and other hardware-related
information.
Federal Communications Commission Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient/relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Note: A shielded interface cable with ferrite core installed on the
scanner connector end must be used with this equipment.
Caution
Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the
user's authority to operate the equipment.