User`s manual

Table Of Contents
Federal Communications Commission (FCC) Statement
CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient/relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Note: A shielded interface cable with ferrite core installed on scanner connector end must be used with this equipment.
Trade Name Model Name FCC ID
ScanMaker E3 MRS-600E3P EF9MRS-600E3P
ScanMaker V300 MRS-600V3 EF9MRS-600V3
ScanMaker V300 MRS-600V3P EF9MRS-600V3P
ScanMaker V310 MRS-600V3 EF9MRS-600V3
ScanMaker V600 MRS-1200V6 EF9MRS-1200V6
ScanMaker V600 MRS-1200V6P EF9MRS-1200V6P