Installation guide
3
4.Connect scanner
1. Check if the FilmView cover is properly installed with
its connector securely connected to its port.
B. USB cable connections
Connect one end of the USB cable to your computer,
and connect the other end of the cable to the scanner’s
USB port.
4. Turn on the Power switch. The green light on the
scanner front panel will blink for a few seconds and
then stays lit. At the same time the FilmView and
scanner lamps also light up.
Mac
PC
PC
Mac
2. Plug the power adapter into the back of the scanner,
and plug the other end into a wall outlet or power
source.
3. Connect either the
FireWireFireWire
FireWireFireWire
FireWire or the
USB cableUSB cable
USB cableUSB cable
USB cable to your
computer and scanner. (
YY
YY
Y
ou can use only oneou can use only one
ou can use only oneou can use only one
ou can use only one
interface at a time.interface at a time.
interface at a time.interface at a time.
interface at a time.)
A. FireWire cable connections
If your system is FireWire-ready, connect one end of
the FireWire cable to your computer, and connect the
other end of the cable to the scanner's FireWire
connector (either one is applicable).
If your system is not FireWire-ready, you will need to
install a FireWire card. For more details on how to
install the FireWire card, please refer to the FireWire
Installation Guide on a separate sheet included with the
FireWire card.
ON
OFF
FilmView cover
5. The system will detect your scanner automatically.
USB port
(labeled with
USB “ ” logo)
FireWire port
(labeled with
“ ” logo)
IMPORTANT NOTES
:
If the system encounters problems, see the Troubleshooting file
in the
TT
TT
T
echinfoechinfo
echinfoechinfo
echinfo folder on your Microtek CD-ROM.
For users who are using
FireWire interfaceFireWire interface
FireWire interfaceFireWire interface
FireWire interface on
Windows 98Windows 98
Windows 98Windows 98
Windows 98
SESE
SESE
SE, and are having problems in activating their FireWire
scanner connection, follow the supplemental steps as
described on the next page first. If the scanner still doesn’t
work, see the Troubleshooting file in the
TT
TT
T
echinfoechinfo
echinfoechinfo
echinfo folder on
your Microtek CD-ROM.