User`s guide

Reference: The Preview window 6-7
Scanner Probe
This command allows you to see the SCSI devices on your SCSI chain and the
Scanner ID number of the devices.
By default, all numbers are selected by the check boxes. To allow ScanWizard 5-
Advanced Control Panel to start up more quickly, select only the boxes that
match the Scanner ID of your scanner (or scanners, if you have multiple
scanners on your system). This will make the ScanWizard 5 bypass the numbers
for your other devices and focus effort on simply detecting scanners. If you're
not sure about which numbers to specify, check all the boxes.
To use the SCSI Chain feature:
1. Choose the Scanner Probe command. The SCSI Chain dialog box will appear.
2. If your scanner does not show, click on the Probe button. Make sure your
scanner is connected and turned on.
3. Make sure too that the correct interface card is shown in the card selection
box. If not, choose the correct interface card.
4. Check the box corresponding to your scanner or scanners. Click OK to
close the dialog box.
Select your
interface card
here.
Click on the Probe
button to update
information or
mount a SCSI
device if it's not
showing in the
dialog box.
SCSI devices are
shown with their
corresponding
Scanner ID
numbers.
To let
ScanWizard 5
start up more
quickly, check
only the boxes
that match the
Scanner ID of
your scanner.
The SCSI Chain dialog box