User`s guide

4-10 Microtek ScanWizard 5
Final Scan and Output Image Destinations
If you are satisfied with the appearance of your intended output image (as
previewed from the preview window), you may now click the final scanning
button. Note that the button may be designated as
Scan, Scan to, Copy, or E-
mail, depending on what environment in which you have launched your SW 5-
Standard (as explained below).
ScanWizard 5-Standard Launched from an
Application
If you have launched SW 5-Standard from an image editing application (e.g.,
Adobe Photoshop, Ulead PhotoImpact, etc.) the final scanning for the output
image is controlled by the
Scan button. This button offers no option other than
to scan your original with the image adjustments you have made (if any). Upon
completion, the output image is delivered directly to your image processing
application. From your application, you may further edit and save the image.
ScanWizard 5-Standard Launched as Stand-
Alone Program
If you have launched SW 5-Standard from Start menu or from the “Go”, “Scan”,
“
Copy”, or “E-mail” start button of your scanner, the final destination for the
output image will vary. Default at first start up is
Scan to.
“
Go” or “Scan” start buttons invokes SW 5-Standard as if it were launched from
Start menu. “
Copy” and “E-mail” start buttons switches the final scanning
button into the
Copy or E-mail button respectively. The Copy button will
prompt you to send the output to printer, while the
E-mail button will invoke
your e-mail editor and attach the output image file with it. However, these
destinations may be aborted and the output image redirected .
Storing Scanned Output Image to File
You need the Scan to button if you wish to store the
output image into a file. If the current button is
already set at
Scan to, click button. The Save As
dialog box (see next page) will immediately display.
If the current button shows as
Copy or E-mail, hold
the pointer on the button for about two seconds or
until the selection menu appears. When the menu
displays, choose
Scan to. The Save As dialog box
immediately displays and the button turns into
Scan
to button.
Hold pointer on the button
for about 2 seconds to
display the menu for
selecting destination of
output image