User`s guide

4-2 Microtek ScanWizard 5
Previewing Your Original Scan Material
By default, SW 5-Standard automatically detects and creates a preview image of
your original in the SW 5-Standard preview window when you first launched
the program.
If you have disabled the auto preview function in the
Preferences dialog box
(see section on Setting Preference in SW 5-Standard in this chapter), you need to
manually click the
Preview button to prescan and preview your original scan
material into the SW 5-Standard window.
If you have disabled the auto detect function as well,
SW 5-Standard will prescan your original as you have
defined in the previous scan session. If the resulting
type of the preview image does not match with your
original, you need to tell SW 5-Standard the actual
type of your original by clicking on the
Original
button. From the resulting menu (see figure at right),
select the nearest scan material category that matches
your original.
NOTE NOTE There is no order of sequence required for using the
image setup buttons in defining various aspects of your image,
i.e., Original, Scan Type, Purpose, Scale Output, and Adjust
buttons.
Create and Manipulate a Scan Frame Selection
If you wish to scan only a segment of your scan material, you can do so by
plotting a scan frame (or a scan job selection) around the chosen area within the
preview image. The area outside the scan frame is excluded from the final
scanned output image.