User`s guide

5-6
Microtek ScanWizard 5 User's Guide (Macintosh version)
Get Scanner Probe Info
This command lets you see the SCSI devices on
your SCSI chain and the SCSI ID number of the
devices.
The Scanner Menu
The Scanner Menu lets you do the following:
• Show your scanner model or select a scanner
if you have multiple scanners
• Get information about your scanner
• Get information about the SCSI chain
• Exit ScanWizard 5
Scanner Model
The top of the scanner menu displays the
scanner model you're using and its SCSI bus and
ID. If you have multiple scanners on your
system, all the scanners are shown with their
respective SCSI bus, IDs, and the current
scanner in use is indicated by a check.
Only one scanner can be accessed at a time. To
switch among various scanners, select the
scanner to be used.
Get Current Scanner Info
This command provides information about your
current scanner, and a dialog box appears
showing the scanner model, SCSI bus, SCSI ID
number, firmware version, and driver informa-
tion.
To use the Get SCSI Chain Info feature:
1. Choose the Get SCSI Chain Info command.
The SCSI Check dialog box will appear.
2. If your scanner does not show, click the
Probe button. Make sure your scanner is
connected and turned on.
3. Check the numbered box corresponding to
the SCSI ID of your scanner or scanners.
Click OK to close the dialog box.
Click here to
update SCSI
device
information
SCSI devices
are shown
with their
SCSI ID
numbers