User`s guide

3-14 Microtek ScanWizard 5 User's Guide (Macintosh version)
Attach Output Image to an E-mail
You need the E-mail button to attach the output image to your e-mail. If the
button is currently set at
E-mail, click the button and the Save As dialog box
displays.
Otherwise, hold pointer on the button for about two seconds or until the
selection menu appears (see top-left figure on previous page). Then select
E-
mail
from the menu.
The button immediately
turns into
E-mail button
while the
Save AS dialog
box immediately displays
with the application check
box enabled by default.
Click to select from the
application icon which e-
mail processor you are
going to use (see figure at
right).
'E-mail' is the e-mail editor (Netscape Messenger, Microsoft Outlook, etc.) you
have previously installed in your host. If none is installed, only
'Internet Mail'
will be available from the application icon.
'Internet Mail' is the Microtek provided e-mail processor embedded in the
ScanWizard 5.
Click the
Save button to execute final scanning, to save the output image to file,
and to launch your e-mail application with the output image attached.