User`s guide

3-4 Microtek ScanWizard 5 User's Guide (Macintosh version)
Specifying a New Scan Frame
To create a new scan frame (instead of using the
existing one), point at any corner over the
image. This changes the pointer to a crosshair.
When the crosshair pointer appears, drag
diagonally until you get the frame you need.
When you release the mouse button, the
previous scan frame is discarded.
Enlarging/shrinking Your Preview Image
ScanWizard 5-Standard allows you to enlarge the preview image up to 4 times
(400%) the size of your original. The zoom scale bar (located at the right side of
your preview image) supports zooming of your preview image. To enlarge
image, select from full scale (100%) to 4 times (400%). To reduce image, click
toward the bottom (or minus [-] button) of the bar; the image is scaled down at
the same increment, with the original size as minimum.
Viewing Hidden Areas of Magnified Image
When the enlarged image is too large to fit within the preview window, click and
drag the Pane tool (see figure above). A panning frame occurs displaying a
thumbnail image. Drag the pane pointer toward the direction of the off-the-
screen area in the thumbnail image, the image will display in the preview
window.
Drag crosshair pointer
to plot a new scan
frame selection.
(previous selection is
discarded.)
Previous selection or
existing scan frame
To magnify image, click on plus
(+) button or on higher scales
To shrink image, click
on minus (+) button or
on lower scales
To view hidden area of
magnified image,
click Pane tool (left).
When panning frame
occurs, drag pane
pointer (right) toward
hidden area of image