Specifications

ScanMaker s460 Supplement 9
Scanning Film with the LightLid 35 Plus II
To scan film, use the LightLid 35 Plus II transparency adapter included with your
ScanMaker s460 to scan film. The LigthLid 35 Plus II is specially designed to scan
35mm slides and 35mm filmstrips. A maximum of 4 mounted slides or one strip of 5
frames can be loaded at a time.
Microtek recommends the use of this accessory to scan slides for on-screen display
purposes or where high resolution is not critical. For high-quality print reproduction,
we recommend purchasing a dedicated slide scanner or a Microtek scanner with built-
in film-scanning features.
Before proceeding with film scanning, perform the procedures below to connect the
LightLid 35 Plus II to your scanner.
1. Unpack the LightLid 35 Plus II.
2. Remove the scanner lid.
3. Make sure that the scanner is powered off; then plug the connector of the
LightLid into the scanner’s 9-pin accessory port.