Specifications

6. Maintenance
6.1 Replacing the lamp
30 hours before the end of the lamp’s life time, the warning message “Lamp life
time is up! Replacement suggested!” will display on the screen. Please replace
the lamp immediately.
Steps:
1. Power off the projector.
2. Unplug the power cord.
3. Cool down the projector for at least 30 minutes.
4. Use a screwdriver to remove the shell and screws on the lamp.
5. Remove lamp.
Remove screws from the lamp
cover with a screwdriver; and
then press down the lock to open
the cover.
Remove screws from
the lamp holder, and
pull out the handle to
replace the lamp in
the holder.
6.2 Cleaning the lens
Please follow these steps to clean the projector lens:
1 Pour an adequate amount of cleanser to a piece of clean soft material. The
lens will be damaged if you use cleansers containing particles, solvent, or
other inferior chemical solvent.
2 Wipe the lens in a circular direction.
3 Cover the lens with the cap if you are not going to use the projector right away.
ＭＸ３ ｍａｎｕａｌ．ｐ６５ 02-12-17, 16:4024