Specifications

Turning on the projector
1. Remove the lens cover.
2. Make sure the signal cables are connected.
3. Plug-in the power cord; the LED indicator will flash slowly.
4. Press the Standby key on the remote control or control panel to turn on the
projector. The LED indicator stays on steady at this time.
5. The message “Warming up! Please wait.” appears on the screen of the
projector. Please wait for 20 seconds or press the Menu key. The projector
will detect the input signal source automatically.
6. If the message “No Signal!” appears on the screen, please check if the
signal source has been activated or if the signal cables have been connected.
Note When power is on, the projector will automatically detect if the projector is
overheated internally. If yes, the LED indicator flashes rapidly and the fan cools
down automatically after 8 seconds. The Standby key does not function under
this situation.
Turning off the projector
1. Press the Standby key to power off the projector lamp.
2. When you press the Standby key, you will see the message “Press Standby
Key again to power off lamp”. Then you can press the Standby key to shut
down the projector, or this message will disappear automatically after 5
seconds.
3. As soon as the lamp is off, the LED indicator flashes rapidly. The Standby
key does not function at this time.
Note: Please wait at least 2 minutes before you turn on the projector again.
You should turn on the projector only after the LED indicator flashes slowly.
4. Unplug the power cord.
Caution To protect the lamp, please do not pull out the power cord right after
the lamp is off. Please wait at least 2 minutes from the time the fan stops.
ＭＸ３ ｍａｎｕａｌ．ｐ６５ 02-12-17, 16:399