Operating instructions

INDEX
SECTION PAGE #
QUICK START GUIDE 2
RECEIVER DESCRIPTION ------------------------------ 3 - 6
FRONT PANEL ----------------------------------------------- 3
REAR PANEL ------------------------------------------------- 4
REMOTE CONTROL ---------------------------------------- 5
WIRING DIAGRAM ----------------------------------------- 6
RECEIVER OPERATION --------------------------------- 7 – 9
HOW TO PROGRAM NEW CHANNELS --------------- 7
REMOTE CONTROL KEY OPERATION --------------- 8 - 9
RECEIVER SPECIFICATIONS ------------------------- 10
LNB DESCRIPTION ---------------------------------------- 11
HOW TO SETUP THE LNB -------------------------------- 11
MAINTENANCE --------------------------------------------- 11
LNB SPECIFICATIONS ----------------------------------- 12
TRANSMITTER DESCRIPTION ------------------------ 13
FCC NOTICE -------------------------------------------------- 13
FRONT VIEW ------------------------------------------------- 13
REAR VIEW --------------------------------------------------- 13
TRANSMITTER OPERATION -------------------------- 14
HOW TO SETUP THE TRANSMITTER ----------------- 14
MAINTENANCE --------------------------------------------- 14
TRANSMITTER SPECIFICATIONS ------------------- 15
TROUBLE SHOOTING ------------------------------------ 16
- 1 -
QUICK START GUIDE
TRANSMITTER SETUP
1. Remove Transmitter from box, select frequency and audio mode.
(Factory set to channel 1)
2. Mount the transmitter at the desired transmit location. Position
transmitter for desired polarity using rear label arrow as a reference,
transmitter and receiver polarity must match one another.
3. Connect power, audio and video inputs to transmitter.
LNB SETUP
1. Remove LNB from box and mount at the desired receive location in line
of site with the transmitter. Position LNB for desired polarity using rear
label arrow as a reference, transmitter and LNB polarity must match one
another. The LNB is weatherproof.
2. Connect cable to the LNB. (Use only RG 6 coaxial cable with the
supplied waterproof “F” connectors to connect Receiver and LNB.
Cable length should be a minimum of 10 feet and a maximum of 200
feet.)
Note: If a dish is used with the system, assemble the dish and mount the LNB in the dish
as described in the dish installation instructions. Position the dish with LNB and connect
the cable to the LNB as described above.
RECEIVER SETUP
1. Remove Receiver from box and position it at the desired receive
location.
2. Connect cable from the LNB to the “RF IN” on the back panel of the
receiver.
3. Connect the audio and video outputs to a monitor.
4. Connect the power using the included 12 VDC power supply.
Trouble Shooting: If video does not appear on the screen or you are having other
operational difficulties, please visit the trouble shooting section on page 15 of the
operations manual or contact MicroTek toll free at [phone] for technical
assistance.
- 2 -