User Guide

17
Installing the Arm
A VESA-compliant arm allows you to mount your monitor on
the wall.
The accepted arm specifications for the monitor are:
• Compatibility with the VESA standard
• Required gap of 100mm x 100mm between the screw holes
for the arm to be attached
How to install the arm
Caution:
• Do not bend the cable too much or add extension cords, as
this may cause malfunction.
• Please refer to the documentation that came when you
purchased the monitor arm, while following the steps below
to install the arm.
• Do not get your fingers pinched between the display and
stand or let the stand drop, as this may cause injury.
• The arm is likely to fall off or break off after being attached to
the monitor.
To install the arm, follow the steps below:
1. Disconnect the cables from the monitor.
2. Place and spread a soft cloth on a flat, stable surface table.
3. Gently place the monitor screen-side down on the table.
4. Remove the cover from the rear
of the monitor by pressing the
( ) icon located at the two sides
of the cover, as shown in the
illustration.