User Guide

3
You will notice the phillips screws inside of the receptacles where the scanner lid posts
(hinges) are inserted. (See illustration below.)
1. Remove the Phillips head screws inside of the receptacles where the scanners lid posts
(hinges) were inserted.
Note: Do not use screwdrivers with magnetic or magnetized tips. Using
magnetized tools around the scanners circuit boards may damage the circuitry,
therefore rendering your scanner useless.
2. You will need to pry open the scanners upper housing. In order to do this without
damaging the scanner we will need a flat head screw driver or a very small pry bar.
Position the front of the scanner facing away from you on the workbench. (See
illustration below.)
Back of the
Scanner