User's Guide Projector CX4
Table Of Contents
- CX4-English.pdf
- CX4-English.pdf
- Connecting To A Set-top Box
- How To Access The OSD Menu
- How To Change OSD Settings
- OSD Menu
- Brightness
- Black Level
- Contrast
- Position
- Image
- Auto Configuration
- Information
- Miscellaneous
- Input Select
- Video
- Save
- Keystone
- Volume
- Projection Mode
- Mouse
- Language
- Computer In and Monitor Connector Pin Assignments
- CX4-English.pdf
Auto Configuration
Entering the “Auto Config.” icon under OSD menu, the projector will automatically
select the frequency and image position for the analog signal.
Information
Entering the “Information” icon under OSD menu, it will present the state of the
image: current resolution (1024*768 or 720*240), H
f
(horizontal scanning
frequency)
& V
f
(vertical scanning frequency) and lamp age (the consumed hours).
Miscellaneous
Entering the “Miscellaneous” icon under OSD menu, you can restore the revised
settings to the defaults. You may also make adjustments for OSD Timeout, OSD
Position, Dithering, Native Mode and Auto Color.
In the Miscellaneous box, there are “Factory Reset”, “OSD Timeout”, “OSD
Position”, “Dithering”, “Native Mode”, ”Color Temperature” and “Auto Color” bars.
Select the “Factory Reset” bar, all the settings you have revised will be
restored to the defaults which are set up before shipment of the projector.
Select the “OSD Timeout” bar, the duration of OSD box displayed on the
image can be adjusted from 5 seconds to 60 seconds; i.e. the time of OSD
box displayed on the image will last for min. 5 seconds to max. 60 seconds.
(The duration will be extended by 5 seconds.)
Select the “OSD Position” bar, you may adjust the position of the OSD box
on the image.
Select the “Native Mode” bar, the projector won’t compress or increase the
pixels but present the image in the original resolution of the input signals.
For example, when the input signal is in 800*600 pixels and entering “Native
Mode”, the image will remain in 800*600 resolution, not 1024*768
resolution. (Note: The resolution of this projector is 1024*768 pixels, XGA.)
Select the ”Color Temperature” bar to adjust the whiteness of a displayed
image. When “Color Temperature” bar move to left, the color of displayed
image will become bluer. When “Color Temperature” bar move to right, the
color of displayed image will become reder.
Select the ”Lamp Life Rest” bar select “Yes” when a new lamp is replaced to
reset the counter of the lamp life back to the beginning. This setting is to
make sure that the projector records a proper update of the life of the newly
35