User`s manual

6
Basic Scanning for PC Users
1. Load the documents to be scanned onto the scanner’s document feed tray.
WARNING: Do not place photo paper or fragile sheets of paper on the feed tray, as doing this will
damage the original photo or frail papers during the feeding process.
2. Launch ScanWizard DI as a stand-alone program by clicking on the ScanWizard DI icon on
the desktop.
3. Click the Scan Setup button in the interface to activate the Scan Setup interface.
4. In the Scan Setup interface, follow the steps below to specify your basic settings.
a) Select ADF (Front Side), ADF (Back Side) or ADF (Duplex) in
the Scan Source as your image input device.
b) Select the appropriate image type in the Color Mode as your
image output type.
– Select RGB Color (24 bits) to scan the image in color.
– Select Grayscale (8 bits) to scan the image in grayscale.
– Select Black & White (1 bit) to scan the image in black-
and-white.
– Select Auto Color Detection to scan the image in color or
non-color based on the automatic judgement and detection
of the system.
– Select Complex to scan the image in color, grayscale or
non-color based on the customization.
c) Select a dimension in the Paper Size as your preview image
size.
d) Select a desired resolution in the Resolution for your image
output resolution.
e) If “Auto-crop” & “Auto-deskew” is selected, the scanner
automatically detects the size of the original image, crops the
full scan frame to fit the image, and removes unwanted black
borders after the scan, as well as corrects the distorted image
for proper alignment.
5. Click the Preview button to perform a preliminary view of the entire image. When done, a
preview image appears in the Preview window. Do not forget to put the document back on
the document feed tray.