User`s manual

18 ArtixScan DI 4020 Plus/ArtixScan DI 2020 Plus User's Manual
Note: There are several precautions and reminders about using the ADF correctly.
Please refer to the section as below for the detail.
• The document feeder is not designed for scanning photos; doing so may
damage your originals. Microtek accepts no responsibility for damage that
may arise from misuse of equipment.
• Do not use the ADF to scan documents shorter than 4.33" (110 mm). A
label attached on the ADF marks the length of 4.33" (110 mm). Make sure
that the documents to be scanned on the ADF are longer than the label.
The Document Feed Tray cannot be used
to scan the length of the document
shorter than 11 cm.
A
T
T
E
N
T
I
O
N
Output Tray Extender
11 cm11 cm
The scanned documents on the Document 
Feed Tray cannot be less than 11 cm.
• The ADF can handle paper within the following specifications:
– Width: 4.33" to 8.5" (110 to 215.9 mm)
– Length: 4.33" to 25" (110 to 635 mm)
– Weight: 10 to 30 lbs. (38 to 110 g/m
2
)
– Feeder capacity: Up to 100 sheets of 24 lbs (90 g/m
2
)
• If the documents are torn, curled, or wrinkled, do not put them into the ADF
to scan, because they may cause paper jams.
• Remove paper clips or staples before placing documents into the ADF. DO
NOT use the ADF to scan documents with paper clips or staples because they
may cause paper jams or damage the scanner.
• If you plan to scan quite amounts of documents, please pull out the Output
Tray Extender for better paper organization.