User`s manual

ArtixScan DI 4020 Plus/ArtixScan DI 2020 Plus User's Manual 17
Positioning Documents
Into the ADF (Automatic Document Feeder)
This section shows you how to position a single-sheet document, as well as a
stack of documents, into the ADF (Automatic Document Feeder).
1. Pull out the Feed Tray Extender for better paper support if the length of the
originals exceeds 10 inches.
2. Load the stack of originals onto the Document Feed Tray, with the side to be
scanned facing up. Push the stack of papers into the tray until the edge of
the stack touches the front edge of the Document Feed Tray.
Document Output Tray
Feed Tray Extender
Document Feed Tray
3. Align stack of originals with the center of the Document Feed Tray by sliding
the two Guide Arms toward the stacked papers if the width of the originals is
less than 8.5 inches.
Guide Arms