User`s manual

ArtixScan DI 2015c User's Manual 39
Maintenance
The rubber pad in your Automatic Document Feeder (ADF) is designed to make
document feeding smooth. After scanning approximately 3,000 sheets through
the ADF, the rubber pad may become worn out, and problems such as document
double-feeds may occur. In this case, check the rubber pad and replace it with a
new one if needed; two rubber pads are included in your scanner package for this
purpose. Follow the procedures below for replacing the rubber pad.
Replacing the Rubber Pad
1. Open the ADF cover by lifting
the two Earlobe Levers on each
side of the cover.
2. With the cover fully opened, press
the two arms of the rubber pad
inward with your fingers to pull
out the rubber pad.
3. Insert and push the new rubber
pad into the compartment until it
snaps into place.
Rubber Pad
4. Close the feeder cover.
Earlobe Levers