Specifications

26 ArtixScan 4500t Installation and Operation Manual
English
C. The Calibration Window: Preview and Scan
1. Preview: The Preview button performs a prelimi-
nary scan of the target, displaying the entire target
image in the calibration window.
2. Scan: The Scan button scans the target image and
prepares the scanner for the important succeeding
steps of aligning the registration marks and
creation of the profile.
D. The Calibration Window: Aligning targets and creating the profile
1. Create Profile: This button starts the actual
calibration process in which a custom scanner
ICC profile is created for the scanner. This button
is grayed out until you have performed the
required alignment of the three registration
marks on the target.
2. Previous Mark: This button lets you go back one
step to align the previous registration mark.
3. Next Mark: This button lets you go forward one
step to align the next registration mark.
4. Go to Step 1: This button takes you back to the
preview image screen so that you can rescan the
target image and restart the calibration process.
5. Show Patches: This option lets you check the sampling area of all the color patches.
When aligned properly, the sampling area appears as a green square in the center of
most patches. If any areas fall outside a patch, realign the registration marks by clicking
the “Previous Mark” and “Next Mark” buttons, and then reselecting the registration
marks until the sampling areas are centered.
6. Close: This button lets you return to the main screen