Specifications

ArtixScan 4500t Installation and Operation Manual 19
English
• Always return the target to its protective sleeve immediately after use.
• Store the target away from light in a cool, dry place, since long exposure to heat and
light can change the colors on the target.
Installing the Scanner ICC Profiler
Note: The Scanner ICC Profiler program should have been installed at the time you performed
software installation procedures (discussed earlier in the manual). If for some reason you have not
installed the Scanner ICC Profiler, follow the steps below to install the program.
A. For the Macintosh
Before installing the Scanner ICC Profiler, you should have ScanWizard Pro and the
Kodak CMS programs installed on your computer.
To install the Scanner ICC Profiler program: Insert the Artix CD into your CD-ROM drive.
Open the ICC Profiler folder, then double-click the Installer icon to install the program.
B. For Windows 95/98/2000/NT 4.0
Before installing the Scanner ICC Profiler, you should have ScanWizard Pro and the
Kodak CMS programs installed on your computer.
To install the Scanner ICC Profiler program: Insert the Artix CD into your CD-ROM drive.
When the Software Installer screen appears, click on the “Install” option for the Scanner
ICC Profiler program, then follow the on-screen instructions until the program finishes
installing.
Placing the color target
With the correct alignment (as shown in the figure below), place the 4" x 5" target in the
metal Main Holder, then place it into the scanner. For further information on how to
place the target, refer to Chapter 4, page 14.
UNLOCK
LOCK