Specifications

ManualsBrandsMicrotek ManualsComputer equipmentArtixScan 4500t

ArtixScan 4500t Installation and Operation Manual 9

English

3. Look for an available PCI card slot in your computer, then

insert the PCI SCSI card (such as the Adaptec AVA-2903E) into

the slot. Push the card in to make sure it is seated all the way

in the slot, then put the screw back into the bracket.

Proper card connection is important, as an improper card

connection will make you unable to use your scanner, and you

will then have to remove the computer case and start the

process of card insertion all over again.

4. Replace the cover of the computer, then plug the power cord back in.

5. Turn your PC back on.

Check the interface card driver under Windows 95/98/2000

With the new SCSI card installed in your computer, when Windows starts, the card is

detected and the driver is automatically installed. You may be asked to insert your

Windows CD-ROM. Do so, and follow the steps below to check your card status.

1. Double-click on the

System System

System icon in Control Panel and

select

Device ManagerDevice Manager

Device Manager from the top.

2. Double-click on

SCSI controllersSCSI controllers

SCSI controllers to display the screen

below. If you are using Adaptec SCSI card, the string

“Adaptec 7850 PCI SCSI Controller” indicates that the

driver is installed.

The message “Adaptec AIC-7850 PCI SCSI Controller”

displays indicates that the driver is installed and the

interface card works properly.

Install the interface card driver under Windows NT

1. Start your computer, and log in as

AdministratorAdministrator

Administrator. Note: You must be logged in as Adminis-

trator in order to install the scanner software components and use the scanner.

2. In Windows, go to

Start,Start,

Start,

SettingsSettings

Settings, then double-click on

Control PanelControl Panel

Control Panel, and double-

click on the

SCSI AdaptersSCSI Adapters

SCSI Adapters icon.

3. Select the

DriversDrivers

Drivers tab in the SCSI Controllers dialog box, and click on the

AddAdd

Add button.

4. From the list of drivers that appear, select

AdaptecAdaptec

Adaptec for manufacturers on the left

(assuming that you are using Adaptec SCSI card), and

Adaptec AIC-78xx PCI SCSIAdaptec AIC-78xx PCI SCSI

Adaptec AIC-78xx PCI SCSI

ContrContr

Contr

olleroller

oller on the right. You may be asked to insert your Windows NT CD-ROM at this

point; do so.

5. You will be asked to restart your computer. Click

eses

es to do so.

Note: If you cannot successfully install the SCSI card, refer to “Chapter 6: Troubleshooting”.

I c

ard