Specifications

10 ArtixScan 4000tf Installation and Operation Manual
Connecting Scanner Using the USB Cable
Before connecting the scanner, check to see if your computer system is USB-Ready. “USB-
Ready” means you can connect the scanner to your computer using the provided USB
cable.
• For Macintosh users, the computer should include a built-in USB interface.
• For PC users, normally the USB interface is built-in on the PC main board and
equipped with a USB port.
System is USB-Ready
If your system is USB-Ready, follow the steps below to make the connection.
1. Connect the power cord to your scanner.
Plug the power cord into the back of the scanner, and plug the other end into a wall
outlet or power source. Make sure no other cable is connected to the scanner except
the power cord at this point.
For Macintosh users — iMac
2. Connect the scanner to your computer, using the provided USB cable.
Connect one end of the USB cable to your computer’s USB port, and connect the other
end of the cable to the scanner’s USB port.