User's Manual

IMPORTANT SAFETY INSTRUCTION
For your protection, please read and observe all safety instructions before operating this system and keep this sheet
and any additional instructions for future reference.
INSTALLATION & USE
OBSERVE WARNINGS: All warnings in the operating instructions should be carefully followed.
WATER AND MOISTURE: The Wireless Ethernet Modules used in this system are weatherproof provided they
are installed correctly. The Power Injection Modules used in this system are NOT weatherproof. None of the
modules in this system are waterproof and should never be submerged. Severe electrical shock, personal injury or
damage to the equipment may result.
POWER SOURCE: Connect the equipment to a power source only of the type described on the operating
instructions or as marked on the equipment.
ATTACHMENTS: Use only MicroTek supplied or recommended Power Injection Modules, Power Supplies,
CAT5 Cables and weather seals and plugs.
WHEN NOT IN USE: Unplug the power if the equipment is left unattended or unused for long periods of time or
during lightning storms
REPLACEMENT PARTS: When replacement parts are required, use only replacement parts specified by
MicroTek Electronics, Inc. Unauthorized substitutions may result in damage to the system and will void the
warranty.
FCC-Required Information Federal Communications Commission
Radio Frequency Interference Statement for Class A Digital Devices
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio frequencies. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This equipment is designed to be professionally installed exclusively for fixed point-to-point applications. These
products must be controlled due to radio frequency power output levels emitted with special consideration given to
antenna placement as it relates to human exposure. Compliance is the responsibility of the installer and user.
Radio Frequency Interface Statement
This equipment has been tested and found to comply with the limits for an intentional radiator, pursuant to Part 15,
Subpart C of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause interference to radio communications. The
limits are designed to provide reasonable protection against such interference in a residential situation. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna of the affected radio or television.
• Increase the separation between the equipment and the affected receiver.
•
Connect the equipment and the affected receiver to power outlets on separate circuits.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this unit to ensure compliance with Class A FCC limits. Changes or modifications
to this unit not expressly approved by the party responsible for compliance could void the users authority to operate
the equipment. Changes or modifications not expressly approved by MicroTek could void the users authority to
operate the equipment.
- ( i ) -