User Guide

ManualsBrandsmicrotech DESIGNS ManualsVehicle Detectionmicrotech DESIGNS 433.39 e-Diagnostic Microtech Wireless Vehicle Detection

High impact PC casing

Silicone rubber cover

IP 65 rated

LCD backlight graphic display

433.39 MHz bidirectional Transceiver

Operates from 2 x 1.5V AAA batteries

Microtech Designs

enquiries@microtechdesigns.com.au

microtechdesigns.com.au

Speciﬁcations

Activation and signal strength

1. Press the MENU button and you will see two selections,

Open RX will be highlighted, press

SET to select. You can

now monitor the e-Loop activation.

2. When the trip level is exceeded, the screen will display the

activation and the level that it tripped at for 2 seconds, to

exit this mode just press the

MENU button again.

3. To test for background interference, press the

MENU button,

now scroll using the down arrow until Signal Strength is

displayed. Press

SET to select or MENU to exit.

4. Low background noise is indicated as 1 to 2 bars, if you see

more than 2 bars displayed constantly, you may have an

interference problem.

This Signal Strength bar graph will also display the signal

strength from our transmissions of remotes or e-Loops.

Although this will only be a short burst, it can be quite useful

in determining signal strength at the receiver end.

2 3

Summary of content (5 pages)

PAGE 1
Speciﬁcations p oo e-L High impact PC casing Silicone rubber cover IP 65 rated M ini LCD backlight graphic display 433.39 MHz bidirectional Transceiver p oo e-L Operates from 2 x 1.5V AAA batteries Activation and signal strength 1. Press the MENU button and you will see two selections, Open RX will be highlighted, press SET to select. You can now monitor the e-Loop activation. 2.
PAGE 2
Connecting to an e-Loop 1. Hold the remote close to the e-Loop and press the CONNECT button. If pairing is successful, Pair Success will display and the red LED will illuminate on the e-Loop. If not successful, the screen will display Timeout. 2. Now press the MENU button. Diagnostics will be highlighted, press the SET button to select. 3. The screen will display the magnetic ﬁeld: 1 2 3 4 1 2 Reading – This should be sitting between 0-200 when no vehicle is present.
PAGE 3
Altering XYZ axis NOTE: We only recommend altering the XYZ axis for complex sites where you need less activation from a particular direction, such as the exit road being close proximity to an entry road. In this instance we would reduce the X ﬁeld direction so that a passing vehicle in next lane will not trigger the e-Loop. 1 Z = Vertical detection Y = Approach and Depart detection (Arrow indication) 2 X = Left and Right-hand side detection 1.
PAGE 4
Changing Radar settings NOTE: Only available for EL00C-RAD and EL0IC-RAD versions. Please contact technical department before altering any radar settings, doing so may cause the e-Loop to be unreliable. 1. After making connection, scroll to Radar Settings and press the SET button. 2. To change any of these settings, navigate to the desired option using the UP and DOWN buttons, and press the SET button to select option. Again, use the UP and DOWN buttons to change the setting and press SET to conﬁrm.
PAGE 5
6 6. The sixth option is Radar INT - this is used to adjust the time between radar reads when in precesnse mode. The default value is 60 seconds, and can be adjusted from 5 to 180 seconds. Press SET to alter. Use Up or Down buttons to change and SET to conﬁrm. If no further changes need to be made, press the UPLOAD button to upload the new settings. Once upload is complete, the screen will display Settings Applied.