User Guide

Troubleshooting
Microsone doesn’t power on
Solutions
The battery is empty
Replace Microsone in the Charging Case to
charge the battery
The battery has a charge
Replace the Microsone in the Charging
Case. Leave it in until the Charging Case
indicates that it is charging. Remove
Microsone again.
I keep losing the audio signal
Solutions
Microsone drops signal from Control Pack
Move Control Pack closer to Microsone
Control Pack is dropping signal from RF
transmitter
Ensure you are transmitting on a clear
frequency and using best RF practices
The volume is too low
Solutions
Microsone output is obstructed with wax
Clean the Microsone with an alcohol wipe to
remove build up from the speaker
AF Audio levels are low
Raise the gain on your transmitter
Microsone beeped and suddenly stopped
working
Solutions
The battery is empty
Charge the battery in the Charging Case,
and use your second Microsone in the
meantime
©Halter Technical LLC
Page 13