User Guide

20
english
21
english
With the Xbox 360 Hard Drive (included) or an
Xbox 360 Memory Unit (sold separately) you
can save games and other media, and enable
Xbox Live sign-in.
Removable Hard Drive
Your Xbox 360 comes with a hard drive
attached but should you ever need to remove
it, use the following procedures for removal
and reattachment.
To remove your hard drive:
1 Turn off your console.
2 Press the tab on the front of the hard drive
and lift the unit from the console.
STORAGE
To attach your hard drive:
1 Turn off your console.
2 Position the hard drive over the hard drive
bay with the thin end (the front) pointed
toward the front of the console, and the
thick end (the back) pointed toward the
back of the console.
3 Place the back of the hard drive against the
back of the hard drive bay. Make sure the
ridge along the back of the hard drive rests
beneath the lip on the back of the hard
drive bay.
4 Push the front end of the hard drive down
until the tab clicks.
Memory Units
You can also connect up to two portable
memory units (sold separately) to the memory
unit ports on the front of the Xbox 360
console for additional storage. Memory units
are smaller than your hard drive, but designed
to be portable you so you can take your Xbox
Live profile or saved games to other Xbox 360
consoles. You can also take your memory unit
to participating retailers and download
content from their Xbox 360 Demo Kiosks.
Up to four controllers, wired and wireless, can
be actively connected to a console at one
time. Each connected controller gets a
quadrant on the Ring of Light. Before you can
connect a wireless controller, at least one
quadrant must be free (unlit). To disconnect a
controller, remove the battery pack from a
connected wireless controller or disconnect a
wired controller cable connector.
To connect your wireless controller to your console:
1 Press the Xbox Guide button to turn on
the controller.
2 Press the Power button to turn on
the console.
3 Press the Connect button on
the console.
4 Press the Connect button on
the controller.
5 After the Ring of Light on the controller
and console spin and flash once, the
controller is connected. The quadrant that
remains lighted indicates the controller’s
position.
ADD WIRELESS CONTROLLERS