User`s guide

Chapter 4 Using the Microcal Diagnostic Utility 93
Drawing and Testing
The Draw program lets you touch the screen and draw lines, shapes,
and curves. Use the Draw program to test the operation of the
touchscreen and pen.
Opening the Draw Program
To open the Draw program, press F3.
Microcal displays a list of keys you can press when using the Draw
program. (Refer to Table 12.) Microcal automatically updates the list
of available keys based on the video mode and the type of controller
being used.
Drawing Tips
Refer to the following drawing tips to familiarize yourself with the
draw program:
Before drawing, press the space bar to clear the screen and display
a blank drawing canvas. You can also press G to clear the screen
and display a grid that you can use as a drawing guide.
If you are using a pen, you can choose between three modes for
drawing: Automatic mode (the same as Pen and Finger mode), Pen
mode, and Finger mode. Press the key for the hardware touch
mode you want.
To draw, simply touch the screen and drag your finger or pen.