User`s guide

Chapter 4 Using the Microcal Diagnostic Utility 87
Communication Settings
The middle portion of the Status box shows the communication port
(COM1 – COM7), the interrupt request (IRQ), the baud rate, and the
data format being used by the touchscreen controller.
The Parameters field lists the data format as follows:
Parity (N=none, E=even, and O=odd)
Number of data bits (7 or 8)
Number of stop bits (1 or 2)
Video Monitor Information and Help Level
The bottom portion of the Status box shows the video card detected,
the current video mode, and the current help level.
To change the video mode, press F5. You can continue to press F5 to
cycle through the available video modes.
Note:
If you change the video mode, you should calibrate the
touchscreen again. The display area is different in each video mode.
To change the level of help displayed, press F2.