User`s guide

TouchWare for Windows NT User's Guide68
Calibrating for Finger Touch and Pen Touch
If you are using both your finger and a pen as touch devices, you must
calibrate the screen twice: once with your finger and once with the
pen. Set the Hardware Touch Mode to Pen Only or Finger Only, and
then calibrate with the appropriate device. The system stores both sets
of calibration data.
Calibrating the Touchscreen
To calibrate the touchscreen:
1. Open the Touchscreen Control program.
2. Select Calibrate. A calibration target appears in the lower left
corner of the screen.
3. Touch the target in the lower left corner. When calibrating a
touchscreen, make sure you
Face the monitor directly.
Perform the calibration in the position (sitting or standing) you
expect to use the touchscreen.
Touch the calibration targets slowly and accurately. The
system does not register the touch point until you lift off the
screen.
Note:
If you do not touch the screen within thirty seconds, the
system automatically cancels the calibration process. In this case,
there is no change to the current calibration settings.
4. Touch the target in the upper right corner.
After you touch the second target, a dialog box reports that the
calibration was successful.