User`s guide

TouchWare for Windows NT User's Guide60
Initializing the Touchscreen Controller
The Initialize option enables or disables the normal touchscreen
controller initialization procedure performed when the driver loads.
If the Initialize Option is Selected
Whenever you start your system, Windows NT tries to load the
touchscreen driver. If the touchscreen driver does not receive the
expected response when it tries to initialize your touchscreen
controller, the system assumes the touchscreen controller is not
present and does not load the driver. The system does not load the
touchscreen driver, because it is not needed if the touch controller is
not present.
The touchscreen controller initialization will fail if power is not
supplied to the controller or the controller is not connected to the
computer when the system boots. Touchscreen controller initialization
will also fail if you specify incorrect communication settings during the
TouchWare for Windows NT installation or in the Hardware Controls
dialog box.
If the touchscreen driver fails to initialize the controller, the driver
places the following message into the installation log file:
The touchscreen controller did not respond correctly
during initialization.
To check the touchscreen driver status:
1. Open Devices in the Windows NT control panel.
2. Locate TNDRIVER and check its status.
The Status column should list Started and the Startup column
should list System.
If the touchscreen driver does not appear in Devices, it has not
been loaded.