User`s guide

TouchWare for Windows NT User's Guide22
6. Type the following to run the MICRO.EXE file to extract the
Microcal files.
C:\MTSNT> MICRO.EXE
The system displays the following messages:
Searching EXE: C:/MTSNT/MICRO.EXE
Inflating: MCAL.OVL
Inflating: MICROCAL.EXE
Inflating: MICROCAL.HLP
Inflating: QCAL.OVL
Inflating: QUICKCAL.HLP
7. Remove the TouchWare for Windows NT diskette from the disk
drive and insert the MS-DOS boot diskette into the disk drive.
8. Use the Copy command to copy the Microcal files from the current
directory to the MS-DOS boot disk. For example, the following
command copies MICROCAL.HLP to the boot disk.
C:\MTSNT> COPY MICROCAL.HLP drive-designator:
where drive-designator is the letter that represents the diskette
drive you are currently using. For example, use A: if you are using
Drive A.
Repeat the copy command with each Microcal file to copy all of
the Microcal files to the MS-DOS boot disk. You do not need to
copy the executable file, MICROCAL.EXE.
For information about using Microcal, refer to Chapter 4.