User`s guide

TouchWare for Windows NT User's Guide20
To copy and extract the Microcal files to a system running MS-DOS:
1. Shut down and exit from Windows NT.
2. Boot your system into MS-DOS.
3. Wait until the system displays the MS-DOS command line prompt.
For example:
A:\> or C:\>
4. Insert the TouchWare for Windows NT diskette into the disk drive.
5. Use the Make Directory command to create a new directory for
the MicroTouch files. MicroTouch recommends you name the
directory \MTSNT (for MicroTouch Systems, Windows NT):
C:\> MD \MTSNT
6. Use the Change Directory command to switch to the directory you
just created:
C:\> CD \MTSNT
7. Enter the following command to copy the MICRO.EXE file from
the diskette to the current directory:
C:\MTSNT> COPY drive-designator:\MICRO.EXE
where drive-designator is the letter that represents the diskette
drive you are currently using. For example, use A: if you are using
Drive A.
8. Run the MICRO.EXE file to extract the Microcal files.
C:\MTSNT> MICRO.EXE
The system displays the following messages:
Searching EXE: C:/MTSNT/MICRO.EXE
Inflating: MCAL.OVL
Inflating: MICROCAL.EXE
Inflating: MICROCAL.HLP
Inflating: QCAL.OVL
Inflating: QUICKCAL.HLP
For information about using Microcal, refer to Chapter 4.