User`s guide

TouchWare for Windows NT User's Guide116
The syntax for the Microcal command is as follows:
MICROCAL [/Cport-number] [/Inumber]
where:
p
ort-number = Specifies the communication port. Valid entries:
any integer from 1 to 7. The default is 1.
This option is particularly useful if you disabled
AutoBaud Detection in the Configure menu.
number = Defines the interrupt request channel to be used
for the touchscreen. Valid entries: any integer
from 2-5, 10-12, or 15. The default is 4.
If you enter... Then Microcal...
A port number Searches the specified port only and all valid IRQs
for the controller.
An IRQ number Searches the specified IRQ only and all valid COM
ports for the controller.
Both a port number and
an IRQ number
Searches the specified COM port and IRQ only.
No port number or IRQ
number
Searches through all COM ports and all valid IRQs
for the controller.
Quitting Microcal
To exit from Microcal and return to the DOS prompt:
1. Access the Microcal Main menu.
2. Select Exit to DOS.
Additionally, you can press Esc to exit from any option or menu.
Pressing Esc returns to the previous menu. If you are accessing the
Main menu, pressing Esc exits from Microcal. Microcal always
prompts for confirmation before exiting from the diagnostic utility.