User`s guide

TouchWare for Windows NT User's Guide102
Saving the Operating Frequency
To save the operating frequency:
1. Make sure the New Frequency box displays the frequency you
want to save.
2. Press Enter to display the levels.
3. Type Y to save the frequency.
The touchscreen automatically uses your new setting each time you
start up the system. The selected frequency remains set until you
change it again.
Note:
Any time you change the frequency, be sure to calibrate the
screen again.
Setting the Baud Rate
You can reset the touchscreen controller to a specific communication
rate (baud rate). The new baud rate is stored in the controller’s
memory.
Depending on the type of touchscreen controller connected to your
system, Microcal may not have a Baud Rate option on the Main menu.
For these controllers, you need to use the AutoBaud option on the
Configure menu. You must first disable the AutoBaud feature and
then set the communication rate. For more information, refer to the
“AutoBaud Detection and Disabling” section later in this chapter.
To reset the baud rate:
1. Select Baud Rate from the Main menu.
A dialog box lists the supported baud rates. The default baud rate
for all MicroTouch controllers is 9600.