Installation guide

Windows NT Installation Guide 19
Boot menu . . .
Supplementary menu . . .
Setup the system . . .
Set default environment variables . . .
Allows you to set the default system partition. The system partition
is the disk partition where the Windows NT osloader, PALcode, and
HAL reside. Choosing this option removes all current boot selections.
If you are unsure of the values for your system, use the following
typical values:
Media: SCSI Hard Disk
SCSI bus number: 0
SCSI ID: 0
Partition: 1
Boot menu . . .
Supplementary menu . . .
Setup the system . . .
Set default configuration . . .
Allows you to describe your system’s monitor resolution, diskette
capacity, keyboard type, and SCSI host ID to the firmware.
If you are unsure of the values for your system, use the following
typical values:
Monitor resolution: 1024 x 768
First diskette drive capacity: 3.5” 1.44MB
Second diskette drive capacity: None
Keyboard: U.S. 101-key keyboard
SCSI host ID: 7
Note: SCSI host ID refers to the SCSI ID of the SCSI host adapter
on a given SCSI bus.