Installation guide

Windows NT Installation Guide10
5. In the Run Maintenance Program dialog box, type the name of the program
to be run at the Program Name prompt, as shown in Figure 4. Then tab to
the Location listbox and select the hard-disk partition, floppy diskette, or
CD–ROM drive from which to run the program.
6. Press Enter to execute the program.
Figure 4 Entering the Program Name
If you are running a utility from a floppy diskette, you can simply type the
utility’s name into the Program Name field, and press Enter. This is because
the floppy drive is the default selection in the Current Partition field.
Use Alt + ↓ when a listbox is selected to open the list.