User's Manual

Introduction
8
■ Using the SU-2 Image Viewer for the first time
1. Press the release
buttons on both sides
of the SU-2 Image
Viewer to lift the cover
up.
Check that the NTSC/
PAL switch is in the
correct position and
that it corresponds to
the TV standard used in
your country.
2. Connect the SU-2 Image Viewer to the RCA connector on your TV.
If your TV does not have a RCA connector, you need a RCA/SCART
adapter, which you can obtain from a hardware shop.
3. Switch on the SU-2 Image Viewer. The Nokia logo appears on your TV
screen.
4. Make sure that your phone is switched on. Then, enter your phone’s
Bluetooth menu and activate the Bluetooth connection.
5. Enter the submenu where you can set the phone to search for
Bluetooth devices, and start the search. The phone searches for all
Bluetooth devices within about 10 meters and shows them in a list.
6. Select the SU-2 Image Viewer from the list.
7. Key in the four digit verification code ("pair") to your phone. The code
is shown on your TV screen in the top right corner.
Once you have keyed in the verification code, your phone sends it to
the SU-2 Image Viewer. See Using the SU-2 Image Viewer with
several paired phones on page 10.
The blue indicator light shows that the Bluetooth connection is
active. The SU-2 Image Viewer appears in the phone menu where you
can view the Bluetooth devices that are currently paired with your
phone.
8. Start using the SU-2 Image Viewer.
SU2_en1.fm Page 8 Tuesday, March 11, 2003 11:00 AM