User's Manual

Introduction

■ Chargers and batteries

Check the model number of any charger before use with this device. The SU-2

Image Viewer is intended for use with the following chargers: ACP-7, ACP-8 and

ACP-12.

Warning! Use only batteries and chargers approved by the

manufacturer for use with this particular enhancement. The use of any

other types will invalidate any approval or warranty applying to the

enhancement, and may be dangerous.

For availability of approved batteries and chargers, please check with your dealer.

When you disconnect the power cord of any enhancement, grasp and pull the

plug, not the cord.

Power supply for the SU-2 Image Viewer

The SU-2 Image viewer uses either the provided AAA batteries or a

compatible charger as a source of power. When connected to a charger,

the SU 2- Image Viewer does not use the batteries. Therefore, the

batteries can be left in the device, even if they are rechargeable.

When using batteries as a power source, the SU-2 Image Viewer

automatically enters sleep mode after 10 minutes, if it is switched on,

but not connected to a Bluetooth device. When the batteries are

running out of power, a low battery icon is displayed on the TV screen

and the SU-2 Image Viewer switches off after 3 minutes.

Installing the batteries

Install the batteries as shown in the picture below.

Note: Always switch the power off and disconnect the device from the

charger or any other enhancement before removing the cover.

SU2_en1.fm Page 5 Tuesday, March 11, 2003 11:00 AM