User`s guide
Table Of Contents
- Software User’s Guide
- Table of Contents
- Section I Windows®
- 1 Printing
- 2 Scanning
- Scanning a document using the TWAIN driver
- Scanning a document using the WIA driver (For Windows® XP only)
- Using the Scan key (For USB or Parallel cable users)
- Using ScanSoft® PaperPort® 9.0SE and OmniPage® OCR
- 3 ControlCenter2
- 4 Network Scanning
- 5 Remote Setup
- 6 PC-FAX software
- PC-FAX sending
- Speed-Dial setup
- Address Book
- Setting up a Member in the Address Book
- Setting up a Group for Broadcasting
- Editing Member information
- Deleting a Member or Group
- Exporting the Address Book
- Importing to the Address Book
- Sending a file as a PC-FAX using the Facsimile style user interface
- Sending a file as a PC-FAX using the Simple style user interface
- PC-FAX receiving
- Index
- RICOH USA
ControlCenter2
3 - 8
3
File
Scan to File allows you to scan an image and save it in a
specific file type to any directory on your PC. This allows you
to easily archive your paper documents. To configure the file
type and save to directory, right-click on the button and select
Software Button or Device Button.
Select the file type for the saved image by selecting from the
File Type pull-down list. You can save the file to the default
folder which is shown currently in the Destination Folder
box, or you can select another folder/directory by clicking
button.
To show where the scanned image is saved when scanning
is finished, check Show Folder box. To specify the
destination of the scanned image everytime, check Show
Save as Window box.
If you want to scan and then crop a portion of a page after pre-scanning the document, check
Show Scanner
Interface box.
Note
For the supported file types, see File attachments on page 3-7.
Downloaded from ManualsPrinter.com Manuals