User's Guide

Table Of Contents

its features and make any necessary information inputs prior to driving. Do not input data or engage in text messaging while

driving. Cellular telephones should not be used when use may be a distraction to the driver.

The Cellular Telecommunications & Internet Association (CTIA) has published further info and tips on safe use of cellular

telephones at www.ctia.org/consumer_info/safety, which we encourage you to review.

Potentially explosive environments

Switch your device off in potentially explosive environments, such as near petrol pumps. Sparks may cause an explosion or fire

resulting in injury or death. Note restrictions in areas with fuel; chemical plants; or where blasting operations are in progress.

Areas with a potentially explosive environment may not be clearly marked. These usually are areas where you are advised to

switch your engine off, below deck on boats, chemical transfer or storage facilities, and where the air contains chemicals or

particles. Check with the manufacturers of vehicles using liquefied petroleum gas (such as propane or butane) if this device can

be safely used in their vicinity.

Certification information (SAR)

This mobile device meets international guidelines for exposure to radio waves.

Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves (radio

frequency electromagnetic fields), recommended by international guidelines from the independent scientific organization

ICNIRP. These guidelines incorporate substantial safety margins assure the protection of all persons regardless of age and health.

The exposure guidelines are based on the Specific Absorption Rate (SAR), which is an expression of the amount of radio frequency

(RF) power deposited in the head or body when the device is transmitting. The ICNIRP SAR limit for mobile devices is 2.0 W/kg

averaged over 10 grams of tissue.

SAR tests are carried out with the device in standard operating positions, transmitting at its highest certified power level, in all

its frequency bands. The maximum recorded SAR values for this device are:

Maximum SAR value Frequency bands used when Maximum

SAR value was recorded

When held against the head 1.15 W/kg over 10g WCDMA 2100

When operated at a separation distance

of 1.5 centimetres (5/8 inch) from the

body

1.14 W/kg over 10g WCDMA 2100

Your mobile device is also designed to meet Federal Communications Commission (FCC) and Industry Canada SAR requirements.

The limit is 1.6W/kg averaged over 1 gram of tissue. The maximum SAR values are:

Maximum SAR value Frequency bands used when Maximum

SAR value was recorded

When held against the head 0.92 W/kg over 1g GSM 850

When operated at a separation distance

of 1.5 centimetres (5/8 inch) from the

body

1.03 W/kg over 1g 2-slot GPRS 850

This device meets RF exposure guidelines when used against the head or when positioned at least 1.5 centimetres (5/8 inch)

away from the body. When a carry case, belt clip or other form of device holder is used for body-worn operation, it should not

contain metal and should provide at least the above stated separation distance from the body.

To send data or messages, a good connection to the network is needed. Sending may be delayed until such a connection is

available. Follow the separation distance instructions until the sending is finished.

During general use, the SAR values are usually well below the values stated above. This is because, for purposes of system

efficiency and to minimise interference on the network, the operating power of your mobile is automatically decreased when

full power is not needed for the call. The lower the power output, the lower the SAR value.