User Manual

FCC DRAFT
• Network type — Select IPv4 or IPv6 as the Internet
protocol type. The Internet protocol defines how data
is transferred to and from your device.
• Phone IP address — Enter the IP a ddr ess of y our dev ice .
Select Automatic to have the network provide the
device IP address. This setting is shown only if you
select Network type > IPv4.
• DNS address — Enter the IP addresses of the Primary
DNS address and Secondary DNS addr. if required by
your service provider or network operator. Otherwise,
the name server addresses are provided automatically.
• Proxy serv. address — Enter the address of the proxy
server. Proxy servers are intermediate servers
between a browsing service and its users, which are
used by some service providers. These servers may
provide additional security and speed up access to the
service.
IP passthrough
Select Menu > Connect. > Data cable > Options > IP
passthrough.
The IP passthrough application allows you to obtain a
network connection on your device from a compatible PC
through a data cable.
Set up a data cable to use IP
passthrough
Use IP passthrough as you use any Internet access point
to browse or synchronize remotely. If a wireless network
connection is unavailable, use IP passthrough to access
the Internet. You cannot use IP passthrough at the same
time as Nokia PC Suite. You cannot activate the modem if
you select IP passthrough in cable connection settings.
To prepare for an IP passthrough session, connect a data
cable to your device, and select IP passthrough as the
connection method. Connect the other end of the data
cable to a compatible PC, and wait for the PC to recognize
your device.
Access point for IP passthrough
Menu > Tools > Settings > Connection > Access points.
To configure IP passthrough basic settings, select
Options > New access point > Use default settings. Enter
a name for your IP passthrough connection in the
Connection name field, and select IP passthrough in the
Data bearer field.
Advanced IP passthrough access
point settings
Menu > Tools > Settings > Connection > Access points.
To use advanced settings, open an IP passthrough access
point, and select Options > Advanced settings and select
from the following:
• IPv4 settings — Enter the Phone IP address and DNS
address for the IPv4 Internet protocol.
• IPv6 settings — Enter the DNS address for the IPv6
Internet protocol.
• Proxy serv. address — Enter the proxy server address.
• Proxy port number — Enter the proxy server port
number.
94
Connectivity
file:///C:/USERS/MODEServer/mehowell/12100235/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 94 Mar 9, 2006 5:37:29 PMfile:///C:/USERS/MODEServer/mehowell/12100235/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 94 Mar 9, 2006 5:37:29 PM